Howard Miller Clock Quartz Movement And Pendulum Instruction

Access to the clock's quartz movement is made in two possible ways: through the front door(s), or through the upper back access panel. Install two "C" size alkaline batteries according to the +/- symbols in the battery holders. For example: if you wish the chimes to be silent from 11 p. m. until 7 a. m., move the switch from to sometime between 10:45 and 11 p. The chimes will automatically become silent each day from 11 p. to 7 a. m. = "Moon" position. Before pursuing service, ensure that all instructions provided with your Howard Miller clock have been carefully followed. FOR MECHANICAL KEYWOUND WALL CLOCKS AND MANTLE CLOCKS. Posted on December 30, 2019 | By clockde. Until after your clock has been. Never spray the cleaner directly on the clock.

Battery operated howard miller clock manual page
Howard miller battery operated wall clock
Battery operated howard miller clock manual available
Battery operated howard miller clock manual available as ebook

Battery Operated Howard Miller Clock Manual Page

In the interim, the quarter hour chimes may sound at the wrong time. Listed below are steps you can take to maintain the exceptional quality of your Howard Miller clock. Each time the CHIME SET button is pressed the number of strikes increases by one count. This is accomplished by bending the hammer arms slightly in the middle so that each hammer rests approximately 1/8″ from each rod or 1/8″ from the coil or bell. By setting the switch to the position and the melody switch to "A", the clock with movement W2115 or W2215 will chime the Ave Maria melody on the hour only, followed by the hour strike. Your clock requires little care and maintenance. Compare time shown on your clock with correct time. WALL AND MANTEL CLOCK. If the clock chimes more than one minute before or after the proper time, the minute hand should be removed and adjusted.

Howard Miller Battery Operated Wall Clock

NOTE: Any time the batteries are removed from the clock, the chime must be reset as described in the HOURLY STRIKE SETTING section. Attach your sales receipt to this manual for future reference. 3:00 location (this insert is not used on all models). The hour hand will move automatically when the minute hand is moved. This hand is not screwed on and should come off easily. Most other alkaline batteries will function properly. Never turn the hour hand to set the time; it will turn automatically with the minute hand (Figure 6). Some models play only the Westminster chime, while others give you a selection of three melodies. Have the Howard Miller model number and serial number and a complete description of the problem available. After setting it to the correct time, it is important that the clock movement be allowed to operate for at least one hour for the chime sequence to become fully functional. Follow these instructions for hanging weights. Make sure the clock is positioned firmly on the floor. Set time by advancing the minute hand (NEVER the hour hand) or turn the hand setting knob at the rear of movement clockwise or counter-clockwise to the correct time. Include your complete address.

Battery Operated Howard Miller Clock Manual Available

CAUTION: When performing this operation be careful not to scratch the hand nut, hand or dial. Following the melody on the hour is the count hour strike. 860 East Main Avenue Zeeland, Michigan 49464-1300 www dot howard miller dot com © Copyright Howard Miller Clocks – Mechanical Chiming Wall Clocks and Mantel Clocks © Clocks Blog and 1-800-4CLOCKS.

Battery Operated Howard Miller Clock Manual Available As Ebook

For clocks with hanging weights, check the weights occasionally to ensure that they are still tightly assembled. SERVICE INFORMATION. Unlock the pendulum holder from its shipping position by pushing it to the right with your thumb or finger. If the dial states "WESTM-SILENT" (Westminster-Silent) or "STRIKE-SILENT", your clock has only the Westminster chime. Follow the remaining instructions as they apply to your clock. Turn the key clockwise until the spring becomes tight and will not turn further.

Step 2: Carefully remove the small nut. Fill the remaining space around the clock, and use enough additional cushioning material so that the clock cannot move or shift in transit. Seal the carton securely with packaging tape. Wind your clock once a week.